![](../ribbons/bunter7.gif)
What you need:
Ribbon
(e.g. curling ribbon, raffia ribbon, ...) in one or two colours
Cut two strings of ribbon that are of about 2 yd length each.
Cross the two strings in the middle and place them in the middle of your palm.
![](round.2.gif)
Fix the crossing of the two strings with your thumb.
![](round.3.gif)
Now put the string from the lower left between the upper two. You can clamp it between your fingers behind your hand.
![](rund.h13.gif)
Then put the string from the upper left to the right.
![](rund.h14.gif)
Afterwards put the string from the upper right down.
![](rund.h15.gif)
Finally, take the string from the lower right, put it above one string and pull it below the left
string.
![](rund.h16.gif)
Now remove your thumb carefully and pull the strings tight. This works best if you pull the strings
diagonally.
![](scoubi14.gif)
Keep repeating this knot until your bracelet is long enough to fit around the
wrist.
©
by kikisweb
|