![](../../ribbons/bunter7.gif)
What you need:
beads (about 4-6mm / 0.16-0.24in),
thin craft wire
Cut off a piece of wire that is about 90cm / 35in / 1yd long.
String six golden beads and twelve white beads onto the wire in the following order: two white beads, one golden bead, two white beads, and so on.
![](kranz.40.gif)
Create a ring out of these beads by pulling one end of the wire through all beads again. Afterwards, the ends of the wire should be equally long and at one place.
![](kranz.41.gif)
String three white beads and then two golden
beads onto both ends of the wire at once.
![](stern.52.gif)
Pull the ends back through the last but one bead
and apply three more white beads.
![](stern.53.gif)
Pull the ends of the wire through the next golden bead of the ring.
![](stern.54.gif)
String three white beads and then two golden beads onto
both ends of the wire at once.
![](stern.55.gif)
Pull the ends of the wire back through the last but one bead again
and apply three more white beads.
![](stern.56.gif)
Pull the ends of the wire through the next golden bead of the ring again.
![](stern.57.gif)
Repeat this pattern until the star is finished.
![](stern.58.gif)
Tip:
Of course you can also create stars in different colours.
![](stern.59.gif)
©
by kikisweb
|